Sponsored Content
WTB one only adjustable rear strut for a 73. 63-79 will work. I bent one.
C3VR Life Member #4
NCM Life Member #994
Vietnam Helicopter Pilots Association Life Member
NCM Life Member #994
Vietnam Helicopter Pilots Association Life Member
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22716
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
What the heck did ya do that for?!! 
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Recken I was where I should not have been. Maybe even stump jumpin. Didn't say that it was the smartest thing I ever did. Still need only one adjustable strut. The bend one has a smile or sad face depending on which way you turn it.
C3VR Life Member #4
NCM Life Member #994
Vietnam Helicopter Pilots Association Life Member
NCM Life Member #994
Vietnam Helicopter Pilots Association Life Member
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
R
Important safety tip;A corvette is not an OFF ROAD VEHICLE
C3VR Lifetime Member #93
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Did it follow the words YEE HAA?
What did the redneck say before the died? "Hey ya all, watch this!"
What did his best friend say before he died? "Shucks, I can do that!"
You could just get one regular strut and use that.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
c
I made a set on a lathe for my 76. It was not all that difficult. I made both in about 3 hrs using 1" stainless steel turned down to 5/8 in the middle between ends (to reduce weight). I left about 3" on each end then drilled and tapped for one right hand and one left hand 5/8" rod end. Added stop nuts and was good to go. Better than the prices for them at vendors.
Phil
Phil
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: Vettes and Vette Parts For Sale
Sponsored Content