Sponsored Content
C
Having new new wheels installed told by wheel installer that he has done a couple of these and on some he gets no air pressure readings when he is done.... Also is there any way to calibrate these sensors??
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
d
The best way to do this is to have "Tire Pressure Monitoring Diagnostic Tool." I have seen it done by placing a strong magnet next to the tire valve on each wheel and turning the key on and hittinig the reset button in the "DIC." It has to be done in this order....left front, right front, left rear, and right rear. You have to repeat these steps for each wheel...turning the key on and off.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
G
Free Member
Send PMSimi Valley, CA - USA
Joined: 7/2/2007
Posts: 18
Vette(s): 2006 datona orange convertable z51 6speed manual
I had wheels replaced just after I bought the car and everything was fine until I picked up a nail in the left front tire The message came on and said right front tire low Apperantly the wheel sensors are set to each wheel does anyone know if the system can be corrected without removing tires and switching positions
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
Its the same scenario as above but you need to do it on the problem wheel only. If you switch wheel positions you'll still get the same low reading if its not reset.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C6 Engines, Driveline and Handling
Sponsored Content