Odometer not working after Tranny rebuild
Forum: C4 Engines, Driveline and Handling
2 Messages
Page 1 of 1
Sponsored Content
j
I noticed after I drove away from a professional transmission rebuilder the odometer was not working. Not knowing where the connections are, could someone have missed something putting it back together? Also, the speedometer stopped working after about 15 miles later too? Also related?
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22714
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Speed sensor was prolly not re-connected properly. The sensor is on the driver side, rear of the trans. Check to see that it is plugged in completely. Also, look carefully to see if the wiring at the connector is good. The insulation on the wires is susceptible to deterioration, leaving you with bare wires. Regardless, the issue is with the speed sensor. Take it back to them and have them correct the problem.
The VSS/speed sensor will look similar to this one.
The VSS/speed sensor will look similar to this one.
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C4 Engines, Driveline and Handling
Sponsored Content