Manifold Air Temperature (MAT) Sensor
Forum: C4 Electrical, Body and Interior
5 Messages
Page 1 of 1
Sponsored Content
j
Hello!
Is the Manifold Air Temperature (MAT) Sensor located under the plenum on an '89 model? If so, that means the plenum must be removed to access correct?
Thanks!
Jeff
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
B
I just relocated mine a few weeks ago , Removing the top plenum is not needed. I found it easier disconnect it from the Passenger side , It's right in line with Cylinder #6 . I used a large flat head screw driver & Needle nose pliers. I would just advise you to make sure you're ready to relocate it ....Because it's a pain in the Arse to get back on ,unless you have really small hands. good Luck .
1 person likes this post
Sign In to Like this post
Sign In to Like this post
j
Great advice!
Thanks Big Mike!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
B
No worries , Hope all goes well ...... you will notice a difference.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Relocated mine also. Makes a difference because you are now measuring cold fresh air instead of hot air in the stock position. Here is a link on Ebay for your '89 http://www.ebay.com/sch/i.html?_odkw=1988+corvette+9th+injector+delete+kit&_osacat=0&_from=R40&_trksid=p2045573.m570.l1313.TR0.TRC0.H0.X1989+corvette+mat+sensor+relocating+kit&_nkw=1989+corvette+mat+sensor+relocating+kit&_sacat=0
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C4 Electrical, Body and Interior
Sponsored Content