Home page

1986 Manual Shifter knob removal

Forum: C4 Electrical, Body and Interior

6 Messages
Page 1 of 1
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

1986 Manual Shifter knob removal

Posted: 3/21/21 9:15amMessage 1 of 6
K
Free Member
Send PM
Washington, IL - USA
Joined: 12/26/2020
Posts: 11
Vette(s): 1986 Coupe. This is from the 1989 VH1 sweepstakes. I won this car in a sweepstakes from thelostcorvettes.com this September. It only has 40,000 miles on it and I am going to spend the winter doing minor things to it. It runs and looks great.

I have the 4=3 with electric overdrive. I want to replace the leather boot but I can't figure out how to remove the shift lever knob. I see the t shaped wedge but How do I get the plastic piece for the push button disconnected?

 

Thanks for any help

Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Re: 1986 Manual Shifter knob removal

Posted: 3/23/21 9:27amMessage 2 of 6
K
Free Member
Send PM
Scottsdale, AZ - USA
Joined: 7/8/2014
Posts: 31
Vette(s): 1988 Dark Red Metallic Convertible with sports seats, Delco/Bose radio system, Z52 suspension

I had an '88 convertible with an automatic transmission but if your shifter has a similar "square" push button on the shifter knob like mine was, then all you have to do is use a thin screw driver to wedge between the push button and the shifter knob and push up to work the button out of the shifter.  I think it is spring loaded so don't lose the spring.  To remove the shifter knob I think there is a snap ring that needs to be removed and then the shifter knob comes off.  Again, that was how I was able to remove my shifter knob from the shifter shaft.  To remove the boot with the knob off you will need to remove the center console and the boot is attached from underneath this center plastic console which is very brittle.  Be careful not to over tighten the screws that hold it or the plastic will break.  I hope this helps.

Be the first to like this post
Sign In to Like this post

Re: 1986 Manual Shifter knob removal

Posted: 3/23/21 1:24pmMessage 3 of 6
L
Free Member
Send PM
Ruthven, Canada
Joined: 4/17/2020
Posts: 5
Vette(s): 1985 C4 4+3 Silver

On my 85, the top of the shift knob pops off, and then the T shaped piece can be removed easiest with a paint can lid opener, the type with the very end bent over.  Once it's pried out, then the knob turns on the threads until it comes off.  There is a spring up the middle for the reverse lockout.  Once the knob is removed, the entire console, shifter boot and all can be removed over the shifter.  No idea if the overdrive wire is a problem, as it was a separate switch on the 85.

Be the first to like this post
Sign In to Like this post

Re: 1986 Manual Shifter knob removal

Posted: 3/26/21 3:25pmMessage 4 of 6
K
Free Member
Send PM
Washington, IL - USA
Joined: 12/26/2020
Posts: 11
Vette(s): 1986 Coupe. This is from the 1989 VH1 sweepstakes. I won this car in a sweepstakes from thelostcorvettes.com this September. It only has 40,000 miles on it and I am going to spend the winter doing minor things to it. It runs and looks great.

I found the answer and it was right in the service manual....geeeeez. It is a t shaped bar that you unwind counterclockwise and keep track of the number of turns. Thia is the electronic overdrive piece.

Be the first to like this post
Sign In to Like this post

Re: 1986 Manual Shifter knob removal

Posted: 4/25/21 6:05amMessage 5 of 6
K
Free Member
Send PM
Washington, IL - USA
Joined: 12/26/2020
Posts: 11
Vette(s): 1986 Coupe. This is from the 1989 VH1 sweepstakes. I won this car in a sweepstakes from thelostcorvettes.com this September. It only has 40,000 miles on it and I am going to spend the winter doing minor things to it. It runs and looks great.

I am ready to put this back together and am wondering where the springs and other piece go. I don’t recall these pieces but they were in the console.

Thanks for any help.

Be the first to like this post
Sign In to Like this post

Re: 1986 Manual Shifter knob removal

Posted: 4/25/21 7:53amMessage 6 of 6
K
Free Member
Send PM
Scottsdale, AZ - USA
Joined: 7/8/2014
Posts: 31
Vette(s): 1988 Dark Red Metallic Convertible with sports seats, Delco/Bose radio system, Z52 suspension

Sorry, mine was an automatic transmission but you might try to look at some Youtube videos that could help.  Something like  https://www.bing.com/videos/search?q=c4+corvette+gear+shift+removal&qpvt=c4+corvette+gear+shift+removal&FORM=VDRE might help.

Be the first to like this post
Sign In to Like this post
Share:

in Forum: C4 Electrical, Body and Interior


Sponsored Content