Sponsored Content
Lifetime Member
Send PMHot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
im with ken then..
valve seal..
you can replace valve seals without pulling the heads..
try that first..
you also might want to go with an umbrella type valve seal
valve seal..
you can replace valve seals without pulling the heads..
try that first..
you also might want to go with an umbrella type valve seal
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
I highly recommend the umbrella type seals. Some of them go on top of the valve spring, and work very well. Much easier, and a good job.
The ones I used to use are discontinued, but someone has to make them somewhere.
The ones I used to use are discontinued, but someone has to make them somewhere.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 HVAC, Fuel, Emissions, and Exhaust
Sponsored Content