Sponsored Content
j
Which way does the water flow through the heater (no A/C on my vehicle)? There is a 5/8" hose that goes to the intake manifold and a 3/4" hose that goes to the water pump.
I have a 195 degree thermostat, and I get some heat, but not a lot. I replaced the shutoff valve in the 5/8" hose, but it did not improve the situation much. I'm thinking of taking the valve out just to see if that makes a difference.
One other thing that I'm thinking a bout is that the heater core may not be working due to residue buildup inside or maybe even bloackage. I do not want to remove the heater core just yet so am wondering if there are any effective cleaner products that will maybe clean out the residue.
I need the heat in Micigan as I still intend the drive the car when the roads are dry.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
R
Ain''t that just the way it is,in the summer time when you don't want it ,it's hotter than hail in your Vette,in the winter time you freeze your bells off



.you can try to flush out the core it self by taking off both heater hoses and with a garden hose flush it out in reverse.but if it is really plugged and you try a full engine flush it usually totally plugs the core and you end up replacing it anyway.I think the hose coming from the water pump is the inlet line into the core,if I'm wrong somebody jump in and correct meRon 78 2010-01-07 12:08:02





C3VR Lifetime Member #93
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Yep, a good flush will probably take care of it. If both hoses are not very hot, as hot as the radiator hoses after full warm up, the core is blocked.kstyer 2010-01-07 17:53:11
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
You stand corected there Ron. The hose comming from the intake is the inlet or hot side. If you want to back flush you go into the water pump hose. If the core is plugged inlet hose will be hotter than the outlet. Be careful of chemicals. Some may be corrosive. I owuld just try flushing it with water. I have an advantage in my shop as I have a flush machine that pulsates water and air.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Disconect the hoses from the engine then back flush, you don't want any of that crap getting pushed into your cooling system. Good luck.
Dave
Lifetime Member #116
Dave's '82
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
m
Not sure if this is same problem. But my sons 78 with air is only blower cold to Luke warm air on hear/defrost/vent. Not sure where to start. Any advice would be greatly appreciated. Thanks
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
my80Vette said: Not sure if this is same problem. But my sons 78 with air is only blower cold to Luke warm air on hear/defrost/vent. Not sure where to start. Any advice would be greatly appreciated. Thanks
I would begin with a flush of the heater core as described in the posts above. Follow that with a separate flush of the radiator and engine block. If nothing appears to be blocked, reconnect and refill. Warm to temperature, make sure your thermostat is opening and double check the temps of the hoses to and from the heater core.
Your sons car may also have a cut off valve installed on one of the hoses to the heater core. That valve shuts the flow of hot coolant to the heater core when the A/C is on, make sure the valve is opening properly to allow flow to the heater core.
Good luck and let us know what you find.
|UPDATED|1/6/2016 2:50:00 PM (AZT)|/UPDATED|
John Sigmund

valkman57@sbcglobal.net
NCRS Member 61302
NW NCRS Chapter Member

Duct tape is the new Black !!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
if I remember right there is a heater control valve rs below exhaust manifold works in vac I replaced it because I didn't like the way it looked,i don't drive this in winter in conn but insummer this car is hotter then hell. I would not use anything to back flush water only,chem open the road to bad things read post most want is written is true
hope it works ,take your time.dwa175
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Free Member
Send PMLoir en Vallee SARTHE, France
Joined: 8/21/2002
Posts: 155
Vette(s): 1978 L48 Auto. Red with Oyster Leather interior. Owned since 1990.
Not sure about the '73, but by '78 the heater system also has "doors" that regulate heat entering the car. Our own 78 suffered a loss of heat last spring and the reason fr that turned out to be that the cable had come adrift of the control lever, positioned behind the glovebox.
So, if the inlet and outlet hoses are both hot, check the operation of the heat control lever by taking the glovebox inner out and watching the lever move as you operate the control.
So, if the inlet and outlet hoses are both hot, check the operation of the heat control lever by taking the glovebox inner out and watching the lever move as you operate the control.
Stephen J Irons
Corvette Club France
Corvette Club France
CCCUK Lifetime Member
Corvettes of Southern California
NCM Family Member
Red Corvettes Have More Fun!
Corvettes of Southern California
NCM Family Member
Red Corvettes Have More Fun!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
yes my 79 cable broke a pain in the--- but replaced, that works fine dwa175
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 HVAC, Fuel, Emissions, and Exhaust
Sponsored Content