Sponsored Content
I blew out a collector gasket on the way back from Hot Springs, not bad but just loud enough to be annoying around town. I put in a set of the copper replacements today. These are supposed to last forever. Has anyone had any experience with these? Just wondering if they are worth the 20 bucks I paid for them
. I replaced the bailing wire with new muffler hangers from the one that broke on the way to Hot Springs. Nice and quiet (Well as quiet as Flow Masters can be!) and no more vibration.
Any day working on a Vette is a good day!!
. I replaced the bailing wire with new muffler hangers from the one that broke on the way to Hot Springs. Nice and quiet (Well as quiet as Flow Masters can be!) and no more vibration. Any day working on a Vette is a good day!!
Mel
Lifetime Member #90 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
L
I had the gaskets blow on me then went with the big block exhaust donuts. The fit indside the collecter flange and header muffler.Never had a problem after that, every so often just check the bolts for being tight.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
[QUOTE=Lynne73] I had the gaskets blow on me then went with the big block exhaust donuts. The fit indside the collecter flange and header muffler.Never had a problem after that, every so often just check the bolts for being tight.[/QUOTE]
Thanks! I will see how these do, so far so good!!
Mel
Lifetime Member #90
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I would rather pay a few extra bucks for the higher quality and longer life if it meant I didn't have to do the labor again.
Sounds like you made a good decision to me.
Save the Wave!
Support the National Corvette Museum
Support the National Corvette Museum
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 HVAC, Fuel, Emissions, and Exhaust
Sponsored Content