Sponsored Content
Lifetime Member
Send PMHot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
[QUOTE=MattK]
Thanks Anthony, good info, especially about siliconing the anti squeak pads on.[/QUOTE]
I used weatherstrip adhesive.. i think it cleans up a little easier..
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
a
I did mine with the sender installed, the antisqueek you get from vette vendors is 10lb roofing felt, I went to the hardware store and got tar and gravel felt and made my own, 4x's the thickness,3M'ed them to the rear,front, cross and tank traps,with mufflers in place but rear hangers disconnected I worked the tank in place and held the tank up with a piece of 1x2 that ran side rail to side rail till I got the front tank crossmember up and the bolts startedanips 38401.8440856481
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
j
Now that's a blow-by-blow description if I ever saw one.....
Thanks, Joe!
JR
P.S. Great tip on the anti-squeak material
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 HVAC, Fuel, Emissions, and Exhaust
Sponsored Content