Home page

Blower help needed

Forum: C3 HVAC, Fuel, Emissions, and Exhaust

8 Messages
Page 1 of 1
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Blower help needed

Posted: 6/15/05 8:21amMessage 1 of 8
w
Former Member
Send PM
Roseland, NJ - USA
Joined: 12/4/2003
Posts: 966
Vette(s): 1974, 454 with 4 on the floor, matching numbers.

I've been following this post and you guys have come up with some great suggestions, on conversions, lines etc. I'm going to order some parts today, and could use some additional advice.

I obviously have a freon leak, I also have a lot of heat coming into the car from my BB & headers, I will be ordering a new heater/AC controller, all related vaccum lines, and AC lines. My biggest problem is that my heater/AC fan sounds like it's on high, but very little air comes through the vents. I haven't found a source for the AC hose/ducts, and I can't find a AC/heater motor with the fan for a 74. Will a 75-78 unit fit ?

Thanks guys 

Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Blower help needed

Posted: 6/15/05 11:36amMessage 2 of 8
Profile Pic
Free Member
Send PM
Frederick, MD - USA
Joined: 9/8/2003
Posts: 3398
Vette(s): 1969 convertible L71 427/435 4-speed black interior
According to the information I have, blower motors from '68-'76 w/ac are the same, and '77-'82 are different. That's just the motors.

You may have a bad blower motor resistor...it regulates the hi-low motor speed. First pull the plug and clean its teminals...sometimes that will fix it...it did mine.
Be the first to like this post
Sign In to Like this post

Blower help needed

Posted: 6/15/05 12:45pmMessage 3 of 8
w
Former Member
Send PM
Roseland, NJ - USA
Joined: 12/4/2003
Posts: 966
Vette(s): 1974, 454 with 4 on the floor, matching numbers.

Thanks Gunslinger, the blower sounds like it's working fine, but very little air comes out the vents. I will check the terminals, it can't hurt anything.

BTW, if you remove the Poet and Mystic form your discription, and add foul mouth, and disfunctional, you'd be discribing me !  

Be the first to like this post
Sign In to Like this post

Blower help needed

Posted: 6/15/05 1:39pmMessage 4 of 8
A
Former Member
Send PM
Portland, TN - USA
Joined: 4/29/2003
Posts: 805
Vette(s): 1972 Coupe Anything, but Stock and more mods to come! SSBC Force 10 Brakes, 3.73, TH350, 355 CID, Rack and Pinion, Vette Brakes suspension front and rear.

Your problem sounds more like a diverter problem.  There are several vacuum controlled doors that direct air to different vents within the car.

Either that or the vents are all cracked up or the seals are bad and the air is just blowing out under the dash instead of our through the vents.

Be the first to like this post
Sign In to Like this post

Blower help needed

Posted: 6/24/05 11:57pmMessage 5 of 8
z
Former Member
Send PM
Savannah, GA - USA
Joined: 1/20/2005
Posts: 936
Vette(s): 1982CE,32,000 and counting. (fast!!) 1981 Vette, black on black. ZZ4 (quick!!)
I agree
Be the first to like this post
Sign In to Like this post

Blower help needed

Posted: 6/27/05 6:04amMessage 6 of 8
w
Former Member
Send PM
Roseland, NJ - USA
Joined: 12/4/2003
Posts: 966
Vette(s): 1974, 454 with 4 on the floor, matching numbers.
[QUOTE=After Shark]

Your problem sounds more like a diverter problem.  There are several vacuum controlled doors that direct air to different vents within the car.

Either that or the vents are all cracked up or the seals are bad and the air is just blowing out under the dash instead of our through the vents.

[/QUOTE]

I believe you guys are correct with the vent thing. Interestingly, I just read an article on that very same topic. I also ran into to C-3 owners at a cruise night on Saturday, one was a 71, and the other was a 74, both had BB with headers, both had the same problem, and the both of them resolved the problem by fixing the vents. Unfortunately, it looks like more than I can handle,  so I'll have to find a good Corvette shop to do the job.

Thanks guys  

Be the first to like this post
Sign In to Like this post

Blower help needed

Posted: 6/27/05 12:12pmMessage 7 of 8
S
Former Member
Send PM
Brighton, Canada
Joined: 3/29/2005
Posts: 11
Vette(s): 1968 Roadster L68 427/4 spd. 1969 Coupe L68 427/4spd.
Another common problem on A/C cars with low air flow is when the evaporator collects dust particles due to the condensation build up, and over time plugs the fins and decreases air flow, I have seen cars completely covered in a dust film, with almost no air flow.  The only way to clean them is to remove it and wash it.  The other thing to check when its out, make sure no corrosion has started due the dust film holding in moisture, could become a future leak.

...rescuing the ones that I can.   Helping others with the ones I can't.
www.stingrai.com

Be the first to like this post
Sign In to Like this post

Blower help needed

Posted: 6/29/05 7:25amMessage 8 of 8
w
Former Member
Send PM
Roseland, NJ - USA
Joined: 12/4/2003
Posts: 966
Vette(s): 1974, 454 with 4 on the floor, matching numbers.

Thanks guys,

I'll be taking apart the whole dash, I've ordered all AC vacume lines, firewall gromet (?) etc. I'll keep you posted.

Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 HVAC, Fuel, Emissions, and Exhaust


Sponsored Content