Sponsored Content
K
My A/C blows out thru the floor vents. I suspect something is amiss with the console controls not routing the air thru the correct passages.
A) Does my hunch seem correct?
B) Must I pull the center console to fix this?
C) Thoughts?
Thanks! KeBo
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22715
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Yes
Yes
No
Prolly have a vacuum line off, possibly in the engine compartment. A more likely cause is gonna be in the control switch(es) in the console. The vacuum switch there can/will dry out over time, and create what amounts to a vacuum leak, so when you move the lever to change the "mode", there is no vacuum to pull the servo and change the door positions.
If you can get in a really quiet area, start it up, close the doors/windows, and listen around the HVAC control in the console for a hissing noise as you move the lever slowly from position to position, stopping in each position for a few seconds to allow the switch to complete the vac. circuit. If you hear a constant hiss, that will be a vacuum leak. You may normally hear a little hiss as the doors change, but a constant hiss is a leak.
You'll prolly wind up changing the control..
Yes
No

Prolly have a vacuum line off, possibly in the engine compartment. A more likely cause is gonna be in the control switch(es) in the console. The vacuum switch there can/will dry out over time, and create what amounts to a vacuum leak, so when you move the lever to change the "mode", there is no vacuum to pull the servo and change the door positions.
If you can get in a really quiet area, start it up, close the doors/windows, and listen around the HVAC control in the console for a hissing noise as you move the lever slowly from position to position, stopping in each position for a few seconds to allow the switch to complete the vac. circuit. If you hear a constant hiss, that will be a vacuum leak. You may normally hear a little hiss as the doors change, but a constant hiss is a leak.
You'll prolly wind up changing the control..

Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
K
Joel - Thanks Bro!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
V
Former Member
Send PMMounds View, MN - USA
Joined: 5/24/2007
Posts: 1034
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
Another common problem is the diaphragm in the actuators. There are several on an AC car. The one that leaks is always the one that is hardest to get to. On my '68. the bad one required removing the gauge cluster, right side dash, and entire heater box. Then 30 seconds to change the actuator.
Good luck
Larry
Good luck
Larry
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
t
My '82 blows air on the ankles, there is ducting there. Maybe your model does not have ducting to the floor.
terntes
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
t
I was checking the assembly manual regarding the vacuum leak to my defroster and the manual indicated and clearly showed electrical wiring routed over the floor duct labeled AC.
terntes
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 HVAC, Fuel, Emissions, and Exhaust
Sponsored Content