Sponsored Content
B
Push-Pin's get epoxied on. I am getting ready to do that, as I purchased factory tye duplicated molded underhood insulation from Zip for this 70.
Center hole in new insulation was off 1.25". I will clip the old center pin off and apply the new one after fitting insulation up and marking new hole area.
Boatman
Center hole in new insulation was off 1.25". I will clip the old center pin off and apply the new one after fitting insulation up and marking new hole area.
Boatman
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
M
My '69 has the insulation, it was all original when I bought it right down to the plug wires. The insulation on mine is only about 1 foot wide at the front of the hood.
Matt
Matt
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
I had to go to the "library" on this one! I have a restoration book that says the insulation was used on "some" 69's, with no consistency, it showed a pic of a small block car with it , then stated it was used mostly on big block cars. 
and it was just a section up front on the hood.
and it was just a section up front on the hood.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
both our vettes have it too. I think it is more for noise level too. 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
A
Former Member
Send PMPortland, TN - USA
Joined: 4/29/2003
Posts: 805
Vette(s): 1972 Coupe
Anything, but Stock and more mods to come!
SSBC Force 10 Brakes, 3.73, TH350, 355 CID, Rack and Pinion, Vette Brakes suspension front and rear.
As far as I know 72's dont have insulation. Mine doesn't have provision for it either
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 General Discussion
Sponsored Content