Sponsored Content
z
I've got two prolems.I'm hopping there is an archived of this.First my headlights.I have to turn on the lights and then go to the front and pull the the lights up with my hand.The right on is real hard one.It's got a lot of resestince(sp)the other light coms up easy.you pull the left about half w
ay and then it will go the rest of the way,How did I do this???The second thng is,Ihave to install a rear brake.My caliper is a gonner. is there some place where somone might have arcived the info.what do.If not please post you anwsers here.Like how do you plug up your lines ect.Thanks for any info.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
h
take a look at corvette fever magazines website in "tech articles".
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
There is really no need to plug up the lines. Just crack it loose then when ready to lift he caliper, disconnect it, drop the other caliper in place and reconnect the line. Make sure the master cylinder is full to start with, and fill it again when the line is connected. Then open the bleeders and make sure the master cylinder stays full when letting the caliper gravity bleed.
One the fluid is running from the bleeders, then have someone pump the pedal and bleed as you normally would. Of course make sure the brake pads are in place before bleeding.
There are some good post about the headlights. Do a search and you should find some good advice.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I had the same headlight problem on my 71. Check all your vacuum lines. I used a Mighty Vac to open lights.If they don't open, you may need acuators or replace the seals. my7T1 2006-10-20 05:25:20
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 General Discussion
Sponsored Content