Sponsored Content
t
Does anybody have a recommendation for a decent engine cleaner. Most of the ones I try make everything look streaked and stained, they are mostly strong degreasers. I have seen some engines that looked impeccable and they must have a special cleaner or technique short of steam cleaning or a lot of work.
terntes
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
a
I cover the distributor and carb and use the car wash, then detail the compartment, and keep it that way
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
To get the engine clean I have always used regular Gunk. the only time I tried to use something else was simple green and shortly after my harmonic balancer spun. I think some of the degreasers damage the rubber components. To the best of my knowledge I have never had anything negitive from Gunk
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Former Member
Send PMManteca, CA - USA
Joined: 11/20/2005
Posts: 3623
Vette(s): 1978,two tone,Metalic Rootbeer & gold
1975 L48 4 speed
I've had success using Castrol (purple container). I like to spray all the electrical connections with wd-40 then the castrol and just hose her down. Afterwards, try spraying everything (except chrome and belts)with WD-40. It leaves a long lasting shine on everything and isn't harmful or hard to get off.
Jimmy B.
Just can't wait to get on the road again. 
Click to see larger views!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
g
Lifetime Member
Send PMIrving, TX - USA
Joined: 8/21/2004
Posts: 4286
Vette(s): #1 -1969 Corvette Coupe Riverside Gold, black interior,MN,A/C,350/350,PS,PB,window cranks.
#2 -2000 C5, black/black, 6 sp, Bose system & lots of buttons.
WD-40 is some really good stuff! 
I took mine to the car wash like "Anips" did, kept the distributor and carb covered. Worked really good with no problems.
I took mine to the car wash like "Anips" did, kept the distributor and carb covered. Worked really good with no problems.
�����
My Link 
MICK - C3VR Lifetime Member #113
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
a
also what I do if the engine is really greasey I take a spray bottle of deisiel fuel to the car wash, let the engine cool a bit spray the engine and suspendsion and let it sit a bit, I don't spray the exhaust manifolds, and the greese comes right off, deisiel has a detergent in it.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
[QUOTE=anips]also what I do if the engine is really greasey I take a spray bottle of deisiel fuel to the car wash, let the engine cool a bit spray the engine and suspendsion and let it sit a bit, I don't spray the exhaust manifolds, and the greese comes right off, deisiel has a detergent in it.[/QUOTE]
Wow Calif. lets you dump that stuff down the sewer with out Arnolds EPA pack hand cuffin ya?
eboBe the first to like this post
Sign In to Like this post
Sign In to Like this post
a
Arni and I used to lift weights together, its cool, car wash's in the Socialist Republic of Kalifornia have seperators, one to recycle water and one for sludge, then Arnold sends the sludge to Mexico its part of our trade agreement, we take illegal aliens and they take the sludge, I'am sure you folks in your socialist state have the same setup sept it goes to Canada,...honest..
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Free Member
Send PMOak Creek, WI - USA
Joined: 5/21/2008
Posts: 2041
Vette(s): 1981 Great White Shark. Red Interior, 350/190 hp. PS, PB (SS), A/C CC, T-Tops. Served three years in Active Duty Army, then Retired Air Force after 34 years! Badger State Vettes Car Club. 175,000 Original miles!! Now own a 1998 C-5!
HMMM sounds like a good idea to me. So far the Legislative Bodies in Wisconsin have not tried this.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
t
I just changed out my water pump and thermostat, I sprayed a ton of the degreaser in the general area of my harmonic balancer and it left an awful appearance. I'm hoping I did not deteriorate much rubber. Thanks for the info.
terntes
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 General Discussion
Sponsored Content