Sponsored Content
M
I'm getting ready to install my trailing arms, I'd like to use the slotted shims to make it easier for the alignment shop to adjust, but I don't have a hole for a cotter pin in my '69. Can I use these shims or will they fall out?
Thanks,
Matt
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
R
Lifetime Member
Send PMKEYPORT, NJ - USA
Joined: 7/6/2002
Posts: 506
Vette(s): 1973 Stingray Coupe and C5 and C6 Coupes.
Unless there is some way to keep the shims in place they will eventually work their way out.
1973 Coupe 
(click to see a bigger version)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Send PMHot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
[QUOTE=MattK]
I'm getting ready to install my trailing arms, I'd like to use the slotted shims to make it easier for the alignment shop to adjust, but I don't have a hole for a cotter pin in my '69. Can I use these shims or will they fall out?
Thanks,
Matt
[/QUOTE]
you should have a hole for a cotter pin..
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
M
Thanks Ben, I found 'em, they were packed pull of dirt and grease.
Matt
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Just drill a little hole for the long cotter pin. It will make your alignment a lot cheaper. I had a customer get charged $600 for an alignment b/c they had to keep pulling the t-arm bolt out just to add some shims.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content