Sponsored Content
k
My Qjet carb inst 100% opening all the way and I need to adjust the cable linkage. I looked and didnt see any obvious way to do this. Is it at the pedal?
kenimpzoom 2008-04-01 17:04:01
76 with L48
Ken
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
There is no adjustment for that cable that I am aware of, other than bending the bracket(or the pedal on the inside).
It is possible that your cable is stretched, as they will over the years.
Another thing to check is the little plastic grommet that fits onto the end of the cable where it attaches to the pedal itself. Sometimes they will wear down a bit, and allow the cable to sit deeper than it should.
Also. make sure your carpeting, or floor mats, if you have them, are not bunching up under the pedal, keeping it from going all the way down.
It is possible that your cable is stretched, as they will over the years.
Another thing to check is the little plastic grommet that fits onto the end of the cable where it attaches to the pedal itself. Sometimes they will wear down a bit, and allow the cable to sit deeper than it should.
Also. make sure your carpeting, or floor mats, if you have them, are not bunching up under the pedal, keeping it from going all the way down.
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content