Sponsored Content
S
Former Member
Send PMFayetteville, NC - USA
Joined: 2/13/2005
Posts: 244
Vette(s): 1968 Corvette Convertable, 4 spd, 350 SB, Daily Driver
I am about to start a rebuild on my brakes. Convert over to o-rings and install new rotors. I want to make sure I measure the runout to get my rotors and spindle parallel. What is the amount of tolerance I should have ? I read .003 thousands of an inch, but cannot find that article anymore. In the near future I am having my wheel bearings done, so this is a practice setup.
JR
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
S
Former Member
Send PMFayetteville, NC - USA
Joined: 2/13/2005
Posts: 244
Vette(s): 1968 Corvette Convertable, 4 spd, 350 SB, Daily Driver
Thanks Joel, that helps a lot. I want to do a good job and write an article for shark bytes about the rotors and converting to o-rings in the calipers.
JR
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content