REPLACING DRIED OUT RUBBER/REAR SPRING BOLTS
Forum: C3 Engines, Driveline and Handling
6 Messages
Page 1 of 1
Sponsored Content
J
Free Member
Send PMMAPLE, Canada
Joined: 3/9/2008
Posts: 164
Vette(s): 70 VETTE 350/300HP, AUTOMATIC, ALL STOCK EXCEPT FOR MILD CAM,LAGUNA GREY, 3:55 POSI GEARS
I WANT TO REPLACE THE REAR RUBBERS ON THE REAR LEAF BOLTS, THEY ARE DRIED UP, HAS ANYONE DONE THIS BEFORE? WHAT ARE THE STEPS INVOLVED? 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Pretty simple. With the Vette on jack stands so the suspension is hanging, clamp a sturdy C-clamp to the spring about 6-8" from the bolt. With a good floor jack, position it between the spring bolt and the C-clamp and jack it up until the tension is off the bolt. Remove the bolt and replace the cushions.
If you have a rear stabilizer mounted to the tops of the trailing arms you'll need to remove those brackets first to get the spring bolt out.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
You also might want to check that rear spring for flatness...If so, time to go.....
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
J
Free Member
Send PMMAPLE, Canada
Joined: 3/9/2008
Posts: 164
Vette(s): 70 VETTE 350/300HP, AUTOMATIC, ALL STOCK EXCEPT FOR MILD CAM,LAGUNA GREY, 3:55 POSI GEARS
THE C-CLAMP JUST GETS MOUNTED ON THE SPRING, 8 INCHES AWAY FROM THE BOLT, WHATS THE PURPOSE FOR THE CLAMP!
THANKS
THANKSBe the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
The clamp(or Vice-Grips) is used to keep the jack from sliding up the spring as you jack it up. The curve of the spring causes the jack to slide towards the center of the car...the clamp keeps it in place. 
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
J
Free Member
Send PMMAPLE, Canada
Joined: 3/9/2008
Posts: 164
Vette(s): 70 VETTE 350/300HP, AUTOMATIC, ALL STOCK EXCEPT FOR MILD CAM,LAGUNA GREY, 3:55 POSI GEARS
THANKS JOEL
I WILL GIVE IT A SHOT!
I WILL GIVE IT A SHOT!Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content