Sponsored Content
L
Has anyone ever used their "George Forman" grill to heat the rear wheel bearings up so they slide on the spindle? I've heard that you can do this. I was wondering how high do you set the grill and for how long? 
If it's not painted, Chrome it!!!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Heating the bearings is one option. You don't want to heat them a lot, or you could damage them. A couple of hundred degrees is okay.
I would rather see you put the spindles in the freezer. Same concept, but the other way around. Leave them in the freezer for at least 5 or 6 hours. It does help.
I would rather see you put the spindles in the freezer. Same concept, but the other way around. Leave them in the freezer for at least 5 or 6 hours. It does help.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
v
Free Member
Send PMShirley, NY - USA
Joined: 2/15/2003
Posts: 108
Vette(s): 1980 currently being restored/ cutomized
Just don't use the microwave!!! 
sorry.
sorry. Vmikalinis, 1980 L48 T-tops 4-spd Hurst shifter, edelbrock intake and carb, mid america true dual exhaust into flowmaster 40's. VDB Poly adjustable strut rods. |URL|http://www.C3VR.com/member_uploads/2501_2600/2544/side.jpg |/URL|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content