Sponsored Content
M
Good morning folks,
According to my 78 AIM, page 293 depicts a stabilizer shaft assy which is
supposed to be attached to the spindle support arm. I've been all
over the rear end and cannot find the stabilizer shaft assy. Is it
possible that I have a different rear suspension system or perhaps
a PO had it removed?????
Any and all comments etc are appreciated.
mk's78 aka mike
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
I beleive that is the rear sway bar assy wich was an option, My 77 doesnot have it installed either.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22716
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
In '78, the rear stabilizer bar would only be installed with the FE7(gymkhana) suspensions, and I believe the ZN1 trailer package option. The bar can be installed on any of them, tho, so if you find a used one, or want to buy a new one, it will bolt on, as all of the needed holes/attachment point are there. 
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content