Sponsored Content
Found a puddle of red fluid on the garage floor on drivers side just inside of front wheel. Friend who is mechanic at Toyota looked under and says its dripping from rack and pinion. Car is a 79 and was in Phoenix and is now in Vegas. Suggestions? Maybe a dried out seal? or the whole rack has to be replaced?
thanks
richard
thanks
richard
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Has the car been driven lately - or sat for awhile? The seals could be dired out some and with recent use - leak . Are you sure its from the rack- pinion. - could it ben a brakeline -caliper -drip?? You can "dust" the suspected fitting with powder and then watch for wetting of the powder -this should confirm which fitting/seal is leaking . That we be MY first step . Find the leak first -
Big Al

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
The car was in Phonix sitting for a few months.
i got the car to Vegas and have used it. It sat for a week and found the leak.
it drives ok and hanndles ok although not great. I dont want to replace more than I have to.
richard
i got the car to Vegas and have used it. It sat for a week and found the leak.
it drives ok and hanndles ok although not great. I dont want to replace more than I have to.
richard
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
V
Hi Richard, Our cars aren't equipped with a rack and pinion steering system unless it has a conversion kit such as Steeroids? If its the stock system.. and its not a leaking from a hose... there's a good chance its probably the steering control valve based on the location of the leak. Check out the link to a picture of one below... does it look like that?
They have rebuild kits for the valve itself... or you can replace the valve with a new one or remanufactured one.
1977 Corvette EX-L48
383 Stroker, Holley MPFI, MSD Ignition, BTO 700R4, VBP Street/Slalom, Hooker Sidepipes with JCL Spiral Baffles, Corbeau A4s w/ Shark Bar and Simpson 5-Points, 17" AR TTII's, Kumho MX's
(click to see a bigger version)
383 Stroker, Holley MPFI, MSD Ignition, BTO 700R4, VBP Street/Slalom, Hooker Sidepipes with JCL Spiral Baffles, Corbeau A4s w/ Shark Bar and Simpson 5-Points, 17" AR TTII's, Kumho MX's

(click to see a bigger version)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content