Sponsored Content
By mistake took of the rear high pressure port fitting - out cam a "lpunger and a spring. Now I know the spring goes in first followed by this "plunger" One und of the plunger fits nicely into the spring - while the other end is larger in diameter looks like it would nest upon the high pressure port hardware forlimg a double piston arrangment.
Any one confirm the position of this "plunger" - small end into spring or reverse
Thanks
Al
Any one confirm the position of this "plunger" - small end into spring or reverse
Thanks
Al
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Without looking, it sounds like you have it correct. Small end in the spring.
|UPDATED|9/18/2004 1:15:16 PM (AZT)|/UPDATED|
|UPDATED|9/18/2004 1:15:16 PM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Ken:
RIGHT as ALWAYS
I was in a parts store and looked at a parts catalog- Just as you said - small end in spring - not that I doubted you but since I was in the store buying "necessary supplies" I took a look
Thanks
Al
RIGHT as ALWAYS
I was in a parts store and looked at a parts catalog- Just as you said - small end in spring - not that I doubted you but since I was in the store buying "necessary supplies" I took a look
Thanks
Al
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
You're welcome
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content