power steering control valve. remove
Forum: C3 Engines, Driveline and Handling
3 Messages
Page 1 of 1
Sponsored Content
question, on the 80 vette I have everything loose on the control valve. The valve will twist but wont come off. I even took the bolt off that holds it to the control arm.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
I used a pickle fork to get the valve off the control arm stud
Hope this helps
big Al
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
V
Former Member
Send PMMounds View, MN - USA
Joined: 5/24/2007
Posts: 1034
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
The valve fastens with a taper fit in the middle, and screws onto the other end. Use a pickle fork as Al said to get the taper fit off, then take out the cross bolt and unscrew the valve from the relay rod. It does not usually unscrew easily, but it will come off.
Larry
Larry
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content