Home page

Posi Clutch Pack R&R

Forum: C3 Engines, Driveline and Handling

3 Messages
Page 1 of 1
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Posi Clutch Pack R&R

Posted: 1/30/05 9:45pmMessage 1 of 3
D
Free Member
Send PM
METAIRIE, LA - USA
Joined: 12/25/2004
Posts: 17
Vette(s): 2000 Hardtop 1991 Zr1 1970 LS5 Coupe

Does anyone have a source for posi rear end parts?

Also, opinion needed: I recently acquired car, have everything behind the driveshaft on the floor, including differential. Differential did not make any noise etc, looks like someone had it apart and put back together with liquid seal. No leaks etc.

Would you have it taken down and checked, bearings/seals/clutch packs before you put it back in?

Bill Folse

Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Posi Clutch Pack R&R

Posted: 1/30/05 11:50pmMessage 2 of 3
Profile Pic
Lifetime Member
Send PM
Hot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
[QUOTE=Domino] Would you have it taken down and checked, bearings/seals/clutch packs before you put it back in?

Bill Folse

[/QUOTE]

I would probably pull the cover and look for wear and chipped teeth..

and i would check for play..  if its in good shape.. i would just replace the seals..

make sure you chisel a small mark on the pinion nut and a reference mark on the shaft to tighten it back to the exact same spot..

the fun part of the whole deal is putting that damn snap ring back on the right side axle shaft.

 

 

Be the first to like this post
Sign In to Like this post

Posi Clutch Pack R&R

Posted: 2/9/05 6:58pmMessage 3 of 3
V
Free Member
Send PM
Clearwater, FL - USA
Joined: 2/8/2005
Posts: 67
Vette(s): ...

I sell rear end parts and we offer rebuilds also. What parts are you looking for? If the diff wasn't making any noise before or leaking, I would just open it up and look at the gears. Like mentioned above, check them for wear or chipped teeth. Your side yokes should move in and out no more than a 1/16" - 1/8". If they do, you should replace them.

 

Dan

Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 Engines, Driveline and Handling


Sponsored Content