Sponsored Content
I'm starting to get a little ping on medium acceleration. If I remember right the fix is timing. My question is which way? Hard to check it when it's not loaded right?
Lifetime Member #73
The Money Pit.... and my niece
(click to see a slightly larger version)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
retard it a couple of degrees.
Joanne 2007-10-14 13:30:55

turn dizzy clockwise
1979 Corvette
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Free Member
Send PMFrederick, MD - USA
Joined: 9/8/2003
Posts: 3398
Vette(s): 1969 convertible L71 427/435 4-speed black interior
I agree. It's either the timing is a bit too far advanced or too low an octane gasoline.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
t
My experience has been from low octane gasoline to timing to a vacumn leak causing a lean ping under acceleration. The timing usually needs to be advanced if memory serves me correctly. I actually had a car burn a hole in a piston on a lean ping under hard acceleration with the turbo kicked in. They said it was low fuel pressure that could not keep up with the air being pushed in by the turbo. Bigger fuel pump and lines cured that after new pistons.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
All of the above could do it! Timing too fat for the fuel/compression ratio, too low octane fuel, or vac. leak allowing more air into the cylinders than it needs, which creates a lean burn, and can cause a hole in a slug.
Turn the dist back clockwise just a hair at a time, until the ping goes away. Then get some better fuel!
If there is a problem with the carb not metering enough fuel under part/full throttle conditions, you'll get the same results.
Did you keep an EGR system when you installed th enew engine? An EGR malfunction is the most common cause of pinging these days...
Turn the dist back clockwise just a hair at a time, until the ping goes away. Then get some better fuel!

If there is a problem with the carb not metering enough fuel under part/full throttle conditions, you'll get the same results.
Did you keep an EGR system when you installed th enew engine? An EGR malfunction is the most common cause of pinging these days...
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Nope no EGR ... Using the best fuel I can get..93 Oct....guess I'll mess with the timing...
Lifetime Member #73
The Money Pit.... and my niece
(click to see a slightly larger version)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
What if it is an '82 with cross-fire injection?
Could it still be timing?
I have noticed that the headlights are coming up and going down slower.
Is that an indication of a vac leak that could be related to pinging?


Save the Wave!
Support the National Corvette Museum
Support the National Corvette Museum
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
[QUOTE=dwright] What if it is an '82 with cross-fire injection?
[/QUOTE]
Yes...
You could also have an injector(or both) stopping up, low fuel pressure due to aged pump, or an issue with an oxygen sensor.
The headlights being slower than normal can be a vac. leak in the system, or just the effects of normal wear & tear on "seasoned" parts. If you have never replaced any of the relays, actuators, or vac. hoses, I'd venture a guess that it is time for a O/H of the headlight system.
Could it still be timing?
I have noticed that the headlights are coming up and going down slower.
Is that an indication of a vac leak that could be related to pinging?
Yes...
You could also have an injector(or both) stopping up, low fuel pressure due to aged pump, or an issue with an oxygen sensor.
The headlights being slower than normal can be a vac. leak in the system, or just the effects of normal wear & tear on "seasoned" parts. If you have never replaced any of the relays, actuators, or vac. hoses, I'd venture a guess that it is time for a O/H of the headlight system.

Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
V
I had that problem for along time, tried all sort of things, timing wasn`t the issue. I finally decided to play around with fuel additives. the one that works for me is a Lucas oil boast for off road. I use it with a full tank and no more ping. I know this worked for me because i just went through 5 tanks of fuel going to Bowling Green and ran out of the boast. lo and behind ping ,ping ping. It cost $9.00 to treat 25 gal, so about $5 a tank.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
In addition, the engine temp could be just a bit higher than before. That will also make it ping.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content