Home page

Pertronix II

Forum: C3 Engines, Driveline and Handling

13 Messages
Page 1 of 2
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Pertronix II

Posted: 4/16/03 12:52amMessage 1 of 13
R
Free Member
Send PM
Atlanta, GA - USA
Joined: 12/10/2002
Posts: 12
Vette(s): 1971 Nevada Silver Convertible LS-5 w/ M21 VIN 15112 1965 Glen Green Convertible L-76 w/ M20 VIN 10409 1965 Ralley Red Convertible L-79 w/ M20 VIN 08298
I used the second version-The "Igniter II" This piece controls the dwell period-for the best spark @ any RPM by checking current levels in the coil. I also replaced my stock coil w/ the "Flamethrower II." The car runs great- starts up hot or cold first try- really woke up my engine and looks entirely stock (I painted the coil black). Will never run points again!!!
Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Pertronix II

Posted: 4/21/03 8:47pmMessage 2 of 13
W
Former Member
Send PM
Kayl, Luxembourg
Joined: 4/10/2002
Posts: 126
Vette(s): 1968 big block convertible 427/435
Hi
Never say never. |biggrin|
I installed the PERTRONIX 1 ignitor and I got told to always carry the points + condenser in the trunk in case the PERTRONIX gives up, which has happened to a few already.
Easy swap back and gets you home. |thumb|
Good luck Gunther
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 4/22/03 10:35pmMessage 3 of 13
a
Former Member
Send PM
Castle Rock, CO - USA
Joined: 4/21/2002
Posts: 179
Vette(s): 1973 T-Top 1993 Coupe
Ditto,

The P-1 literally fell apart on our car and the current one in there has an intermittant miss that has to do with the power lead.

Keep us informed as to your experience.

Alex |smokin|
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 4/30/03 11:37pmMessage 4 of 13
W
Former Member
Send PM
Kayl, Luxembourg
Joined: 4/10/2002
Posts: 126
Vette(s): 1968 big block convertible 427/435
Hi
Yes, I also didn't watch it and connected the PERTRONIX behind the coil resistor. All worked fine till the radiator electrical fan started up. The engine kept on dying and I had to raise the idle RPM to above 1000 to get home.
This was due to the momentary Voltage drop and due to the resistor already keeping the PERTRONIX at minimum operating Voltage, it momentarily missed.
Now, after I corrected this and hooked it before the resistor, I can reduce the idle RPM again and even with both Ventilators starting up, all keeps running fine.
This PERTRONIX does need the full 12 Volts all the time.
Make sure, you have it connected this way.
Gunther
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 5/9/03 10:37pmMessage 5 of 13
r
Free Member
Send PM
Joined: 8/25/2002
Posts: 4
I'm interested to understand what has gone wrong with your Pertronix Ignitor or Ignitor II. Did the control module fail? The magnetic ring destruct? I'm wondering if I should buy as spare, in case mine fails. I've used an Ignitor in my '69 Vette (350/350). So far it's been great. Noticeable difference when starting, running cold, accelerating.

Thanks.

|UPDATED|5/9/2003 10:37:22 PM|/UPDATED|
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 5/12/03 3:17pmMessage 6 of 13
p
Former Member
Send PM
WEST HAVEN, CT - USA
Joined: 8/12/2002
Posts: 107
Vette(s): 1971 coupe brands hatch green with saddle interior
I just replaced the second Pertronix unit. I changed to the lectric limited set up, its one wire. I hope this works out I was getting more miles out of the points.
Pozz |wavey|
|IMG|http://www.C3VR.com/member_uploads/1301_1400/1385/casey_driving2.jpg|/IMG|
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 10/9/03 5:53pmMessage 7 of 13
1
Former Member
Send PM
Joined: 7/17/2003
Posts: 38
I also have had a Pertronix 1 installed for almost 5 years with no problem. I would like to know what happens when they go, maybe it is time to buy another and keep on hand in case the old goes. I will never use points again!
Charlie Carr |IMG|http://thumbs.webshots.com/s/thumb4/6/58/92/88765892IdgKRN_th.jpg|/IMG|
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 10/11/03 6:53amMessage 8 of 13
t
Free Member
Send PM
Joined: 2/17/2003
Posts: 58
Vette(s): 1969 427 coupe 1972 350 coupe
I have used the Petronix II and Flame thrower coil on my 72 for the last 3000 miles. It has been flawless to date. Easy to install and no maintenence. At this point I would recommend one highly. I bought it on the internet for 89.95, shipping included, and put my original parts in a bag in case I want to go back stock.
tom hargrove
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 10/11/03 7:42pmMessage 9 of 13
t
Free Member
Send PM
Joined: 2/17/2003
Posts: 58
Vette(s): 1969 427 coupe 1972 350 coupe
To the guy that asked me where I bought my Pertronix II for 89.95, I'm sorry, but I screwed up and erased your e-mail address. I hope you get this. I bought it on ebay. Go to Pertronix and you will see his auction. I just checked and he is still selling them for that price. It is johnsmustang.com out of Houston, Tx. He has an 800 number with his entry. Email me back if you don't find it and I will help if I can. Sorry for the screw up.
tom hargrove
Be the first to like this post
Sign In to Like this post

Pertronix II

Posted: 10/13/03 8:04pmMessage 10 of 13
C
Former Member
Send PM
Anacortes, WA - USA
Joined: 12/16/2002
Posts: 1293
Vette(s): 1979 Red #72 C3 Corvette,T-350,Black interior,air,tilt/tele,K&N.And a 1978 Olds Cutlass 350/350,auto,air,2-dr.,buckets
I had a problem on a trip to town when the '77 just died,then didnt start after cranking.Had a Summit GM HEI 50k distributor lying around for another engine.Its now in my Vette.Works fine. |thumb|

Jon,-Majestic Glass Corvette Club-....Red #72,blk.interior,1979 C3 Corvette-TH350,Weiand,Holley,glass tops,Pioneer,3.55's,K&N,Dynomax,Flowmaster 40's,Energy Suspension,Spicer,VB&P(pics soon); 1978 Olds Cutlass Supreme 350/350,Dk. Blue 2-door Coupe-Hotchkis,PST,K&N,XM...'99 Mitsubishi Galant GTZ V6,black/grey leather,intake,strut bars,tint... |IMG|http://www.msnusers.com/cutlasscorvetteworkinprogress/shoebox.msnw?action=ShowPhoto&PhotoID=63|/IMG|

Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 Engines, Driveline and Handling


Sponsored Content