Sponsored Content
A
Need a little help here guys, I am in the final stages of a from scratch build and I purchased a Miloden high volume oil pump and an ARP oil pump drive shaft.
My question, Is the drive shaft supposed to be loose fitting on the oil pump or do I need to do something to make it clip in place? previously the shaft has always been connected by a plastic keeper that snaps on holding it on the pump firmly but I have chosen to go the ARP way.
I have stopped the build until I know that everything is going to be right... dont want the shaft falling off.
Thanks
Andy
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22715
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Looks fine to me. As long as it has a way to keep the shaft fairly centered on the pump, it's all good. It can't be really tight, since there does need to be some flexibility to compensate for stuff not being totally aligned. What you have there should work great. Just be sure to install the shaft with the pump....you'll never be able to get the shaft in from the top.
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
A
Ok Joel, thanks for that. will finish the build today.
Much appreciated
Andy
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content