Sponsored Content
s
Former Member
Send PMColorado Springs, CO - USA
Joined: 9/11/2004
Posts: 67
Vette(s): 1978 Silver Anniversary Edition Paint, L-48, Matching numbers, 350 c.i, 625cfm Demon Carb, Weiand Stealth intake, 268 Custom Ground Cam, 10:1 heads, Jet Hot Hooker Headers, 3:73 rear end.
In the middle of putting a new manifold on my motor and cannot find the torque spec sheet in the manual. Luckily its a cold day and the Permatex will take some time to dry. If anyone can let me know that would be great.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Free Member
Send PMFrederick, MD - USA
Joined: 9/8/2003
Posts: 3398
Vette(s): 1969 convertible L71 427/435 4-speed black interior
According to my shop manual, it's 30 ft/lbs.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
s
Former Member
Send PMColorado Springs, CO - USA
Joined: 9/11/2004
Posts: 67
Vette(s): 1978 Silver Anniversary Edition Paint, L-48, Matching numbers, 350 c.i, 625cfm Demon Carb, Weiand Stealth intake, 268 Custom Ground Cam, 10:1 heads, Jet Hot Hooker Headers, 3:73 rear end.
Cool, Thanks a lot.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
V
I`ve installed a pair of Hooker super comp headers and side exhaust.
I have a leake where the tubes meet the collector. Leake on the top on the drivers side, and a leak on the bottom of the passenger side. There is only one bolt to tighten this joint,and i got it as tight as i can get it. Any suggestions?
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content