Sponsored Content
201482913352r.jpg)
who,just spent 5 hrs getting balancer off.
broke my toy puller.
but abit of 1/2'' plate, welder and drill made a puller and got it off.
1979 Corvette
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Send PMAsh Fork, AZ - USA
Joined: 4/18/2007
Posts: 1058
Vette(s): 1981 Red Interior White exterior
Good job
Feels good when it gets done!
Feels good when it gets done!
Dave C..........My mantra: I can not be bought!! Long and short term leases available.
In the words of Zora Arkus-Duntov "Is your seat belt fastened? Alright, Let's go"
Yeah, I know, Shut up Dave.
Yeah, I know, Shut up Dave.
Lifetime Member #192
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Been there done that. I went through multiple pullers trying to get a balancer off once. All I can say is good
luck getting it back on. I had to hammer the heck out of it to get one back and I worried that I damaged the main bearing. I swore the end of my crank had to have been mushroomed somehow.
I've since installed another motor and someone else is stuck with that crank/balancer now :)
luck getting it back on. I had to hammer the heck out of it to get one back and I worried that I damaged the main bearing. I swore the end of my crank had to have been mushroomed somehow.
I've since installed another motor and someone else is stuck with that crank/balancer now :)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
well if it that tight. think I would run some run some rubbing paper thru it a few time and look for burrs/dinks.
1979 Corvette
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content