changing tranny mount '70 vert auto
Forum: C3 Engines, Driveline and Handling
3 Messages
Page 1 of 1
Sponsored Content
e
Former Member
Send PMEasthampton, MA - USA
Joined: 5/27/2007
Posts: 114
Vette(s): 1970 corvette conv, 350 auto.
Hello, had a broke engine mount, wich I sucssesfully chnged out, I bounght a tranny mount at the same time,....just in case.. Is it a bigger project to change, or not too bad for a novice, Thanks..........any "tricks" to make job easier MUCH APRRECEATED!!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
LOL....the trick is getting it high enough. They are not hard at all to change, a couple of bolts are a PAIN, but nothing a novice can't handle. I did mine after I got my lift, so it was pretty easy, and it was an Arizona car, so no rust issues. Good Luck!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Easy enough. As Mike says, get the car high enough to crawl under it. Then you'll need to have a jack handy to raise the rear of the trans a little. Then it is simply a matter of removing the bolts, two holding the mount to the trans, and two holding the mount to the crossmember. 
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content