Sponsored Content
Well I replaced all the calipers, finally got all of them bled out . Opened the garage and looked on the floor to find brake fluid under two of the tires. What gives here. Did I really get two bad calipers? This can't be normal. They are still under warranty, but its just the agravation




Mike
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
R
Lifetime Member
Send PMKEYPORT, NJ - USA
Joined: 7/6/2002
Posts: 506
Vette(s): 1973 Stingray Coupe and C5 and C6 Coupes.
Oh that can't be good.
Is it the caliper pistons or the bleeder valve or the brake line or ????

Is it the caliper pistons or the bleeder valve or the brake line or ????

1973 Coupe
(click to see a bigger version)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
v
Free Member
Send PMShirley, NY - USA
Joined: 2/15/2003
Posts: 108
Vette(s): 1980 currently being restored/ cutomized
I know that I had to make my bleeder valves pretty tight so that they wouldn't leak, but I have speedbleeders in there. I would be REAL careful about tightening them though.
Vmikalinis, 1980 L48 T-tops 4-spd Hurst shifter, edelbrock intake and carb, mid america true dual exhaust into flowmaster 40's. VDB Poly adjustable strut rods. |URL|http://www.C3VR.com/member_uploads/2501_2600/2544/side.jpg |/URL|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I took the rear wheel off. Looks like the bleeders are OK. Must be a piston. Oh Nooooooo
Mike
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
Did you replace the flex lines when you did the calipers? You may also want to check to be sure the steel ines from the flex to the caliper are in good shape and properly seated. Both of these are prone to failure and the steel lines are a booger to seat sometimes.
It's possible the new calipers are bad, but check all your connections first.
It's possible the new calipers are bad, but check all your connections first.

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content