B&M converter controller for my OD auto trans
Forum: C3 Engines, Driveline and Handling
3 Messages
Page 1 of 1
Sponsored Content
I just installed a B&M contorller. I got mine fromEbay for $160 after using a 10% off coupon.
Redwingvette 2008-07-03 05:35:04
It works real good with my setup, BTO Trans install. I have it set to lock the converter when I hit 43mph and it disengages when I slow down to 40mph. I use to have to either downshift or turn off the lock-up converter if I slowed down and tried to speed back up again. If I didn't, the motor would chug or ping until the trans downshifted or I got the speed back up to above 40mph.
It is a little pricey but I think it was worth it.
Brian - NCM Lifetime Member
73 coupe L48, Flat-top pistons, Performer RPM Heads, Crane Cam and roller rockers, Holley 650 vac sec. Performer intake,
3.55 gear BTO 200-4R trans,
Leather seats, Seatbelt Plus 3point seatbelts, Pioneer CD player
Magnaflow Exhuast System
Dewitt radiator and dual electric fans
Borgeson Steering box
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Sounds like its working much like the factory setting. Glad it's working well.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
The nice thing about this setup is you can adjust it to what your needs are by a turn of th dial. It operates off a sensor that attaches to the speedo cable without any mods.
Brian - NCM Lifetime Member
73 coupe L48, Flat-top pistons, Performer RPM Heads, Crane Cam and roller rockers, Holley 650 vac sec. Performer intake,
3.55 gear BTO 200-4R trans,
Leather seats, Seatbelt Plus 3point seatbelts, Pioneer CD player
Magnaflow Exhuast System
Dewitt radiator and dual electric fans
Borgeson Steering box
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content