Home page

Another Can I Do This Question

Forum: C3 Engines, Driveline and Handling

3 Messages
Page 1 of 1
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Another Can I Do This Question

Posted: 8/14/10 1:42pmMessage 1 of 3
Profile Pic
Free Member
Send PM
edgwood, MD - USA
Joined: 11/1/2007
Posts: 737
Vette(s): 1975 convertible,with the hard top and power streering.it a 350 L48 with auto trans. the color is light blue.
 First let me say thanks again to Larry  at Corvette Specialties for his advice this morning.After I checked my u-joints I'm 90% sure that they are ok.I am going to recheck after I replace the left strut. That my question the strut by being bent is putting pressure on the bolts that hold it.I can rotate the cam bolt ,but it dosen't losen anything up.I have the car on stands and so I assume that the spring is unloaded.So to get the bent strut out I want to cut it with a sawzall.Will this work or do I have to do anything else to the spring?
                                           Rick
Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Another Can I Do This Question

Posted: 8/14/10 4:14pmMessage 2 of 3
r
Lifetime Member
Send PM
North Charleston, SC - USA
Joined: 3/20/2004
Posts: 4208
Vette(s): 1975 L48 AT AC T-top
I don't think the spring is completely unloaded so I would not do anything that could case the supension to unwind and hurt you.
 
Scott
Be the first to like this post
Sign In to Like this post

Another Can I Do This Question

Posted: 8/14/10 7:43pmMessage 3 of 3
Profile Pic
Lifetime Member
Moderator
Send PM
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22715
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/ Am-Fm/map light National/Regional/Chapter NCRS "Top Flight" #2-1985 Bright Red/Carmine Cp.L-98/auto Member: NCRS, NCRS Texas, Corvette Legends of Texas
With the tires hanging down, the strut rods will have some twist applied to them, due to the t-arm "arc" as it moves up/down. You can put a jack under the t-arm, and jack the arm up, and get the rods out. Be careful to position the jack in a manner that is safe. You can do this with the spring still attached, or you can take the end link bolts out, but then you have to deal with safely removing the tension from the spring.
You could also take the strut rod bracket loose from the diff....just 4 bolts hold it to the bottom of the diff. Taking the bracket loose will eliminate the twist problem, but it won't eliminate the fact that there is still a little pressure on the rods from the wheels hanging down. You will be able to get the rods out, tho.

Joel Adams
C3VR Lifetime Member #56    

My Link


(click for Texas-sized view!)
             NCRS

"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"

Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 Engines, Driveline and Handling


Sponsored Content