1981 Engine oil leaks and trans leaks
Forum: C3 Engines, Driveline and Handling
10 Messages
Page 1 of 1
Sponsored Content
r
Hello,
I am a new vette owner just bought mine last summer on ebay put a new interior in it, suspension and brakes it is now safe on the road but it has engine oil leaks it looks like valve covers, oil pan maybe, and auto trans pan leak. I was just going to head to the local parts store and get a trans kit valve cover gaskets and a oil pan gasket and get to work. Is there any special tricks or problems i should watch out for?
I am a new vette owner just bought mine last summer on ebay put a new interior in it, suspension and brakes it is now safe on the road but it has engine oil leaks it looks like valve covers, oil pan maybe, and auto trans pan leak. I was just going to head to the local parts store and get a trans kit valve cover gaskets and a oil pan gasket and get to work. Is there any special tricks or problems i should watch out for?
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Free Member
Send PMCramerton, NC - USA
Joined: 8/22/2006
Posts: 1094
Vette(s): black 1982 coupe slate gray interior, 350 crossfire, 1985 fuel pump, Steeroids R&P conversion
Jeff, Your 81 will have all of the same emissions "stuff" on it as mine does, the valve covers are a PITA to get too but just take your time, and wiggle them out, they will come but you may have to do some slight bending on the emissions hard pipes that come out of the top of the headers, they will stand some "slight" bending, just dont get to heavy handed. The one way the large one way valves on the emissions pipes can be removed with some effort but will give you about an inch more room when removing the covers. Not a bad job, but one that will lead to skinned knuckles and lots of blue language. I sure envy those guys with the clean, roomy non-emissions engine bays.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Send PMHOWELL, NJ - USA
Joined: 5/18/2004
Posts: 6812
Vette(s): 1979, Targa Blue (72 Color), Pace Car rear spoiler, L88 hood, Dark blue factory interior, 525HP 406, HD 700R4, 370 gears,Steeroids, composite rear spring, TT IIs wrapped in T/A Radials.
If you see a clear path for the oil from the valve covers, that's a likely suspect. The oil pan is a bit of a challenge, but if you drop the center link of the steering down from one side, you'll have plenty of access.
In terms of the trans pan, a common area that leaks is where the selector arm comes out of the transmission and the cable attaches to it. I did my pan gasket just to fund out that this was the real culprit...also check you trans dipstick tube where it goes into the transmission.
Good luck and have fun cleanin' her up!
LukesVette Homepage
Veteran of Operation Iraqi Freedom
101st Airborne(AirAssault!)
God Bless America
Support Our Troops
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
r
Thanks for the info i figured that more than a few people have been down this road before.

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Former Member
Send PMManteca, CA - USA
Joined: 11/20/2005
Posts: 3623
Vette(s): 1978,two tone,Metalic Rootbeer & gold
1975 L48 4 speed
Projects like this are very satisfying when completed. Love those '81s
.

Jimmy B.
Just can't wait to get on the road again.
Click to see larger views!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
It might be worth it to have the engine bay steam cleaned and then watch to see where the leaks are originating.


Save the Wave!
Support the National Corvette Museum
Support the National Corvette Museum
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
o
I had a 81 and it was leaking from rear engine seal which made it look like it was coming from the transmission.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
R
Also check out where the speedometer cable goes into the tranny,there is an O-Ring that sometimes takes a dump,I had to replace mine,you have to pull out the drive gear housing to do it,you will loose fluid when you pull it out,stand back, 
Ron 78 2007-03-26 08:42:40

C3VR Lifetime Member #93
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Free Member
Send PMCramerton, NC - USA
Joined: 8/22/2006
Posts: 1094
Vette(s): black 1982 coupe slate gray interior, 350 crossfire, 1985 fuel pump, Steeroids R&P conversion
Another possible source for your oil leaks could be the oil pressure sending unit located just to the drivers side of the distributor, it's a black plastic piece with a wire connector on top that screws into the block. When they leak, the oil drips down both sides of the transmission bell and blows back onto the transmission and on the back of the engine block.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
There is also a "passing gear" cable that goes into the auto tranny. Replace the seal.


Save the Wave!
Support the National Corvette Museum
Support the National Corvette Museum
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Engines, Driveline and Handling
Sponsored Content