window adjustment directions

PM me and I will email you a couple of Pdf's I have on this. or let me know how I can insert pdf's and everyone can see them

Hey send some my way. ossw1@starstream.net

if youll email them to me (use address in my profile) ill put them online for everyone to download

http://www.VetteRegistry.net/member_uploads/9601_9700/9627/Door-window-Adj-2.JPG
http://www.VetteRegistry.net/member_uploads/9601_9700/9627/Door-window-Adj.jpg

here are the directions i downloaded quite a while ago. will try to rescan them from my manual and see if they come out any clearer. hope this helps. dave

i just rescanned in pdf format but cant figure out how to post. will email them if you give me your email address.



eddie208752010-04-28 06:54:55

here is the adjustment procedure copied and pasted here hopefully i will be what you need. you can used the diagram from last post.

COUPE MODEL
Glass Adjustment Procedure
1. Install the side door glass rear w/strip attaching screw "J".
2. Install the w/shield post w/strip retainer.
3. Install the w/shield post w/strip to the retainer and with
the weatherstrip aligned with the retainer and located flush
with the top surface of the w/shield header end cap, install the
upper weatherstrip attaching screw "A".
4. Install the side door w/strip attaching screws "K" & "L".
5. Install all door glass and related hardware with all adjustment
attachments loose.
6. Install roof panels and fit to body. See Section B-B.
7. Fit door to body and adjust door s triker.
8. With door closed and side glass down, operator inside of unit;
with the use of a vacuum suction cup applied to inside of door
gLiss, rolls side door glass up and fits the glass snugly into
the front, upper and rear weatherstrips. See Section A-A,
D-D & E-E. He should then tighten adjustment attachments
starting with the lower screws marked "F" and "G" on sheet
F01-7. Then tighten screws "C". Then all other adjustment
screws should be tightened except screws "E". Then glass
should be rolled down far enough to check the angular relationship
of the glass to the weatherstrips and adjusted as required
using screws "C". Then glass should be rolled completely
down and back up and upper stops adjusted (screws "E".) Then
glass should be rolled down and lower stops adjusted attaching
screws "H". NOTE- Lower stops can be adjusted at any time
during the procedure .
9. Adjust w 'shield post and roof panel weatherstrip retainers as
required to provide uniform fit of glass to weatherstrips. See
Sec.:i..Jn A-A & Section C-C.
10. As a final check, roll glass down away from weatherstrips and
up and check for fit and rolling effort. Also open door,
roll glass partially down and then roll glass up against
and close door. Check for swing clearance to body and glass
to weatherstrips fits. Readjust as required.
11. After adjustment is completed and checked, tighten all door
glass related fasteners to specified torque.
12. It is vitally important that doors and roof panels be correctly
fit and latched prior to any final fitting of the door glass or
weatherstrips.
13. It is imperative that all contacting surfaces of door glass
channels and rollers be well lubricated and that proper torque
be maintained on all roller and channel attachments to the door
glass and on all power window regulator attaching screws when
so equipped. eddie208752010-04-28 07:06:32

[QUOTE=Ron 78]O.K. guys I got em thanx a bunch,looks like a lot of work[/QUOTE]

that's the key statement---looks like a lot of work. if all your hardware is ok then adjusting should be pretty quick. it's a lot easier than the directions make it out to be.