Sponsored Content
C
Does anyone know how to adjust the left rear portion of the driver's side T-top so that it will fit relatively flush with the body on a 1975 model? My passenger side top fits very well but the driver's side angles upward from the center to the outside edge just enough that it bugs me.
2012101154624r.jpg)

Build Date: May 7, 1975. 383 w/267 RWHP/310 RWTQ
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
C
Thanks Bob. It looks like item #3 in the picture is possibly needing adjustment on mine.
2012101154624r.jpg)

Build Date: May 7, 1975. 383 w/267 RWHP/310 RWTQ
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
V
Free Member
Send PMGreer, SC - USA
Joined: 3/13/2012
Posts: 264
Vette(s): 1978 Black with Viking mural painted under hood AM/FM/CB radio, T-top and a 2013 Cyber Gray Grand Sport Coupe, 2LT for my daily driver
FLUSH?????? I have a '78 with glass tops. I never liked that they did not fit flush, but then I saw other '78's and those did not fit flush either. I agree, a flush fit would look so much better. Can glass tops on a '78 be adusted to fit flush?
David
Warning: The surgeon general has declared that it is NOT unhealthy to smoke your competition AND I just discovered that my corvette is a hybred. It burns gas and rubber!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
C
VikingVette said:
FLUSH?????? I have a '78 with glass tops. I never liked that they did not fit flush, but then I saw other '78's and those did not fit flush either. I agree, a flush fit would look so much better. Can glass tops on a '78 be adusted to fit flush?
David
Unfortunately, no. The glass tops sit about a 1/4 inch higher than the body by design. My fiberglass tops are pretty good on the passenger side, just the driver's side that is a bit higher at the outside. I made a few adjustments last night and it's better; just not as good as the passenger side.
2012101154624r.jpg)

Build Date: May 7, 1975. 383 w/267 RWHP/310 RWTQ
1 person likes this post
Sign In to Like this post
Sign In to Like this post
I noticed the same thing on my 75, rear of driver side top sitting high. Pushing down lined it up without much pressure. Turned out to be a missing latch adjustment bolt. You can get them for $4-$5 with the rubber cap. Adjust these if necessary.
Good luck

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
my 1979 has glass tops,just got of body resto,tops still poped up,,been adjusted may times there never going to fit right dwa
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
your right,left side ok,right not going to happen dwa
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content