Home page

Top removal?

Forum: C3 Electrical, Body and Interior

11 Messages
Page 1 of 2
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Top removal?

Posted: 5/31/04 2:15pmMessage 1 of 11
E
Former Member
Send PM
Harrisburg, PA - USA
Joined: 10/22/2003
Posts: 34
Vette(s): 1968 Safari Yellow Convertible 327/300 HP, 4-Speed, and not much else!
|withstupid|
I have a guy lined up to put on the new convertible top.
Question, I am to rermove the old one and leave a bare frame. Since some of you must have done this before, where do I start & stop? I don't want to start ripping & tearing and screw it up!
Thanks.
Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Top removal?

Posted: 5/31/04 3:18pmMessage 2 of 11
Profile Pic
Lifetime Member
Send PM
Hot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
if it will save you money take it off.. if not leave it on..

i would highly recommend a new fastener set (screw set)
Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 5/31/04 9:14pmMessage 3 of 11
a
Free Member
Send PM
sonoma, CA - USA
Joined: 8/9/2002
Posts: 784
Vette(s): 72 LT-1 AC coupe,69 l-36 coupe
Before you have the new top installed the time to adjust the top is before the material is installed with only the frame work and weather strips installed-no pads or vinyl-the top is adjusted to fit the windshield header,deck lid,and door glass,may times the door glass is out of adjustment and has to be dialed. After all the adjstments are made, bring the car to the shop to have the material installed, most trim shops don't do these adjustments.....Latest Corvette Fever
Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/3/04 8:53pmMessage 4 of 11
Profile Pic
Lifetime Member
Moderator
Send PM
Burke, VT - USA
Joined: 1/23/2002
Posts: 7615
Vette(s):
SOLD - "The Toy" - '70 Convertible
SOLD - "The Beast" - '90 ZR-1 (#682)
SOLD - "Betty" - '28 Ford Model A Tudor
SOLD - "BLKBRRD" - '78 Pontiac Trans Am
"BLUBYU" - '04 Coupe
The shop I went to did both the removal of the old top and the install of the new one. I had thought about doing the job myself (bought an Al Knoch top kit) but after doing some research on what all was involved felt it would be money well spent to have it done by a pro. Best $350 I've spent so far...!!!

Jim Olson 

"The Toys"...!!!  Save the Wave!

Where I've been in a Corvette...!!!

Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/4/04 9:01amMessage 5 of 11
Profile Pic
Free Member
Send PM
Scott, LA - USA
Joined: 2/26/2004
Posts: 303
Vette(s): 77 L82 coupe
Question. I know how to adjust the door glass, but how do you adjust the top to the door glass? Ive got a small gap between the top and the top of the door glass and cant figure out how to tighten this up. Any ideas?
Glenn





Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/4/04 2:20pmMessage 6 of 11
a
Free Member
Send PM
sonoma, CA - USA
Joined: 8/9/2002
Posts: 784
Vette(s): 72 LT-1 AC coupe,69 l-36 coupe
"This is done by removing the door panels
and tweaking the various
adjustments of the window tracks and upper and lower window stops,door glass can be adjusted quite a bit,including height and angle to compensate for gaps".....Corvette Fever.
Check your shop manual for your year and model, should tell ya.
Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/4/04 2:57pmMessage 7 of 11
P
Free Member
Send PM
Wayne, NJ - USA
Joined: 5/31/2002
Posts: 973
Vette(s): White 1975 L48 Stingray 129,000 Miles, daily driver.
FOLLOW THE ORDER!!!! I tried just tweaking it and it got REALLY BAD!! Had to get out a Haynes? or a Chiltons and look up the proper order. I could only get it close, not "right." Neither window will close all the way with the doors closed, and drivers side never does.

Scot
Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/4/04 7:38pmMessage 8 of 11
Profile Pic
Lifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
Don't give up. Keep tweaking. As you make minor changes you can see what happens. They can be a pain, but once you figure it out they are not too bad. You can do it.
Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/4/04 7:38pmMessage 9 of 11
Profile Pic
Lifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!
Scott, do you have your car back?
Be the first to like this post
Sign In to Like this post

Top removal?

Posted: 6/5/04 10:10amMessage 10 of 11
P
Free Member
Send PM
Wayne, NJ - USA
Joined: 5/31/2002
Posts: 973
Vette(s): White 1975 L48 Stingray 129,000 Miles, daily driver.
 kstyer said: Scot, do you have your car back? 


No... |sad|
Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 Electrical, Body and Interior


Sponsored Content