Roll bar for 74, thoughts, suggestions?

I'm wanting to add a basic roll bar into my 74 convertible such that I can attach 4 or 5 point seat belts to the bars and hopefully have an SCCA compliant roll bar at the same time. Would also be nice if I could still use the soft and hard tops as I'm not yet ready to make this into a 100% race car.

Anyone have any experiences with roll bar installations and/or brand recommendations to share?

Thanks,

George Lehmann

The roll bar can be found , I did it once a few yrs ago ...I think it was some place in or near Danville,Pa. You will have to gut the interior first.  Went & looked   http://autoweldchassis.com/cp.ivnu I bought a nice roll bar for my 67 Dodge from them. Give them a call ..real nice guys & very helpful

 I installed these in my 73..these are Fiero seats

 I made 2 brackets like this to attach the seat belts

 Bracket attached to rear

Cheers,

This is the 4-point roll bar before it goes off for sandblasting and powdercoat. I took the two back bars to a middle install point on the crossover frame rail that goes over the rear end, made a steel plate, and drilled 3 holes to bolt that piece on with 3 grade 8 bolts. The two front arms get welded to frame points behind the seats.

This is how the roll bar looked sitting in the car while I was fitting it.

The final product with the 5-point harnesses installed.

Cheers,

George