Home page

Replacement of Headlight Actuators

Forum: C3 Electrical, Body and Interior

18 Messages
Page 1 of 2
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Replacement of Headlight Actuators

Posted: 7/17/04 5:57pmMessage 1 of 18
M
Standard Member
Send PM
NEWARK, DE - USA
Joined: 6/11/2002
Posts: 29
Vette(s): 1971 Coupe 4 speed, 350ci, 270 hp
Anyone have experience with replacement of hdlt actuators? The Installation Manual and close up look indicate that there may be 4 bolts to remove the entire assembly, rather than trying to replace the actuator in place. Any thoughts? Appreciate the help.-Mike |saluteflag|
Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Replacement of Headlight Actuators

Posted: 7/17/04 7:54pmMessage 2 of 18
8
Former Member
Send PM
Joined: 1/29/2002
Posts: 1049
Mike, why do you want to replace them? Faulty?

|UPDATED|7/17/2004 7:54:43 PM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/18/04 3:40amMessage 3 of 18
S
Free Member
Send PM
Phoenix, MD - USA
Joined: 11/23/2003
Posts: 57
Vette(s): 82 Silver/Gray with 80k miles, rear 275/60/15,
hi,

yes! i replaced my 82 front left actuator about 8 months ago. you need to take the four bolts off you mentioned as well as one of the small cross bars that are held in place with a cotter pin and two springs. the cross bar that has the 'eye hook' screw that attaches to the actuator shaft. this 'eye hook' screw is/was/can be very hard to get off. mine snapped the shaft of the old actuator when i attempeted to remove it. i had to heat it up to get the old shaft piece out. this 'eye hook' piece is almost impossible to get so be very careful.

mark v
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/18/04 4:24pmMessage 4 of 18
M
Standard Member
Send PM
NEWARK, DE - USA
Joined: 6/11/2002
Posts: 29
Vette(s): 1971 Coupe 4 speed, 350ci, 270 hp
Many thanks!
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/18/04 4:27pmMessage 5 of 18
M
Standard Member
Send PM
NEWARK, DE - USA
Joined: 6/11/2002
Posts: 29
Vette(s): 1971 Coupe 4 speed, 350ci, 270 hp
I have replaced the vacuum tubing and switches and am still experiencing poor/eratic operation of the headlights. Have read the troubleshooting guide and seems as though this may be where my problems are.
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/18/04 4:35pmMessage 6 of 18
S
Free Member
Send PM
Phoenix, MD - USA
Joined: 11/23/2003
Posts: 57
Vette(s): 82 Silver/Gray with 80k miles, rear 275/60/15,
have you replacedthe actuator? there is a rubber seal inside the actuator that cracks and lets air leak out.

try this, with the car running be in front of the car with the hood up. have someone in the car putting the lights on/off. listen for a low hisssssss sound. that is where the air is leaking. listen by each actuator, by the hoses running to/from the actuators and by the hoses in front attached to the actuator.

mark v
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/18/04 4:49pmMessage 7 of 18
M
Standard Member
Send PM
NEWARK, DE - USA
Joined: 6/11/2002
Posts: 29
Vette(s): 1971 Coupe 4 speed, 350ci, 270 hp
Thanks Mark!
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/29/04 6:28pmMessage 8 of 18
M
Standard Member
Send PM
NEWARK, DE - USA
Joined: 6/11/2002
Posts: 29
Vette(s): 1971 Coupe 4 speed, 350ci, 270 hp
Thanks Mark, purchased a couple of spares based on your experience-let you know how I make out.-Mike |saluteflag|
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/29/04 6:39pmMessage 9 of 18
Profile Pic
Lifetime Member
Send PM
Hot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
even easier and more accurate is to take the most important tool in your garage for working on corvettes.

your vaccum pump (with gauge).. just pump the mechanism up by hand and see it it leaks.. either pick the head light end or the dash end first and test each component on the way.
Be the first to like this post
Sign In to Like this post

Replacement of Headlight Actuators

Posted: 7/29/04 8:01pmMessage 10 of 18
8
Free Member
Send PM
Joined: 3/22/2004
Posts: 179
Vette(s): 1982 COLLECTOR EDITION
I agree,the hand pump vacuum gauge can solve all mysteries in the headlight system.Well worth the investment. |cheers| |thumb|
Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 Electrical, Body and Interior


Sponsored Content