Sponsored Content
Ok so a few months back I bought a spoiler on Ebay. I am eventually going to get the entire rear of the car painted, but want to try my hand at it first by doing this spoiler.
So my question is this. I notice there are some spider cracks in the paint. Do I need to completely remove all the paint or can I just sand it smooth?
If I prime it do you think the cracks will reappear?
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Ummmmmm on the spoiler????
ebo

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Yes sir just the spoiler....Im not actually putting any paint on the car.....
I do have it sanded at 120
|UPDATED|7/23/2012 5:00:36 PM (AZT)|/UPDATED|
|UPDATED|7/23/2012 5:00:36 PM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Well unless you sand em out I'd say they have to return. If your guna paint it soon anyhow just spray it and see. Be a good test.
ebo

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Is the spoiler the original urethane from '78-79 or fiberglass? Could be wrong but I think if it's urethane you're suppost to use some kind of special flex primer.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Dan, you cannot paint over cracks if you want the new paint to last. THAT'S WHAT HAPPENED WITH MY CAR! You can paint anything without much prep. The question is, how long will it last? Do it right the first time, Buddy!

Barry

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Jeffm said: Is the spoiler the original urethane from '78-79 or fiberglass? Could be wrong but I think if it's urethane you're suppost to use some kind of special flex primer.
Im pretty sure its fiberglass...Its pretty rigid...
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Dan,
I agree with Barry. Still sanding & prepping mine. Be sure to use a block, & sand w/80, prime, then 180, prime if needed, then 220 wet sand. You won't regret doing it right. Just my 2 cents.
Mike

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content