Sponsored Content
Gold Member
Send PMScotch Plains, NJ - USA
Joined: 1/11/2006
Posts: 247
Vette(s): 1981 Corvette Coupe, Stock, Black on Black,
4 Spd
I purchased a set of nice lookin doors @ Carlisle awhile back and getting round to prepare and install them. First clean-up then I want to test the electric mirrors, power windows & power door locks. I have a 12vDC PS to test with. 
I'm thinking I might need test harness & a switch to simulate on car connections.
Any suggestions would greatly be appreciated.
Jeff
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
V
Former Member
Send PMMounds View, MN - USA
Joined: 5/24/2007
Posts: 1034
Vette(s): 70 LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 convert, 85 coupe, 93 coupe
Here is the pertinent section of the wiring diagram. You can just connect test leads to the components. Note that the window motor plug has just the "IN" side for up and down. You must ground to the motor housing to complete the circuit.
Larry
Larry
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
If you use a power supply, make sure to limit the current, use the fuse sizes in the car as a go by.
Dave
Lifetime Member #116
Dave's '82 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Gold Member
Send PMScotch Plains, NJ - USA
Joined: 1/11/2006
Posts: 247
Vette(s): 1981 Corvette Coupe, Stock, Black on Black,
4 Spd
Sorry guys, been at the Jersey shore for a couple of days for some R&R with the family.
I'll check out the electrics & test tomorrow.
Thanks Larry & good point Dave for the fuse size.
Jeff
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content