http://www.VetteRegistry.net/member_uploads/2101_2200/2183/pass%20doo r%20trim%20c3vr.JPG
http://www.VetteRegistry.net/member_uploads/2101_2200/2183/dr%20door% 20trim%20c3vr.JPG
Check out my new door sill trim. Easy to install and looks great!


Sign In to Like this post
Looks nice, was just working on my Vette and my door plates look wimpy now. LOL. Where did you get them from?
Denny
Sign In to Like this post
Did you get them from Mid-America?
I like your carpet too. Is it new?


Support the National Corvette Museum
Sign In to Like this post


MARK
LIFETIME MEMBER #117
Click here to see my new friend P-Racer
"Keep up the Pace"
Sign In to Like this post
They are from Mid America. They use the original trim on one side add the center piece and a new trim on the inside edge. I replaced my original pieces at the same time since they were fairly scratched compared to the new piece. If you decide you want to go back to the original look at a later date, take out the new trim screws, touch up the small carpet holes and you are done.
My carpet was replaced a number of years ago by the PO. I have actually considered replacing it again but keep finding other things that are higher on the list.


Sign In to Like this post
Very nice And a nice interior overall! Did you replace your dash? It looks great!
Luke
LukesVette Homepage
Veteran of Operation Iraqi Freedom
101st Airborne(AirAssault!)
God Bless America
Support Our Troops
Sign In to Like this post






�����
My Link
MICK - C3VR Lifetime Member #113
Sign In to Like this post


Sign In to Like this post