Need picture of starter harness to main harness
Forum: C3 Electrical, Body and Interior
1 Message
Page 1 of 1
Sponsored Content
Hey guys & gals,, been a long time since I've been on here, mostly because the Vette has been sitting AGAIN. I had a meltdown at the connector where the main harness plugs into the starter harness (against firewall next to the distributor) on my '79. Can anyone get a detailed pic of the harness connectors at that point? Seems like I have a couple extra wires. It's the 6pin connector with 8 wires (2 are doubled up) going into it. PS: I also did away with the little brown connector right next to it,, no longer have A/C in the car. Thanx in advance,,, Bill A
|UPDATED|2/3/2019 9:35:44 PM (AZT)|/UPDATED|
|UPDATED|2/3/2019 9:35:44 PM (AZT)|/UPDATED|
EdelBrock Performer w/ 750 doub pumper,port/polished heads, triple cut valves w/4th cut down the throat of the exhaust valves, 286 Comp Magnum cam, 1.6 roller rockers, ball-peen pushrods w/guides, screw in rocker studs w/girdles, Comp double-roller chain, , hi-rise valves covers w/ spacer (needed for the girdles), Flowtech by Holley long-tube ceramic coated headers into Stage II pipes (no cats), chrome wire looms for the MSD 8.5 mm wires, MSD 50,000v coil kit w/advance springs, cap, rotor, module, steel-braided radiator,heater,vacuum hoses, Infinity Kappa 4x6 plates (dash), Sony Xplode 6 3/4" (rear), chrome T-stat housing, A-arm shields, B&M Hammerhead shifter
|IMG||/IMG|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content