Sponsored Content
For all the 79/80 Vette Owners that have put the MSD box in , could you tell be the best/easiest location to install the box,the car is not stock and doesn't have any of the emission plumbing on it and I'm still finding it hard to locate somewhere it could be installed and look clean.
Thanks Tom
Thanks Tom
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
T
80,
I'm not sure if it is too far away or not, but I have seen them mounted in the rear interior compartments behind the seats of some earlier C-3's.
Anthony
I'm not sure if it is too far away or not, but I have seen them mounted in the rear interior compartments behind the seats of some earlier C-3's.
Anthony
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Send PMHot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
I mounted mine on the inner fender on the passenger side..
makes the wiring clean also
makes the wiring clean also
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
l
Free Member
Send PMNewark, CA - USA
Joined: 4/29/2004
Posts: 350
Vette(s): 1969 Corvette 4-speed ZZ-4 crate
Monza Red
Me too
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
R
Lifetime Member
Send PMKEYPORT, NJ - USA
Joined: 7/6/2002
Posts: 506
Vette(s): 1973 Stingray Coupe and C5 and C6 Coupes.
I put mine on the fender on the drivers side.
1973 Coupe 
(click to see a bigger version)
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
mine is behind the pass dash
|COLOR=RED| |/COLOR||IMG|http://www.c3vr.com/member_uploads/2201_2300/2262/sigbanner.jpg |IMG|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
4
There is plenty of room for it in the wiper tray area ,there it can get plenty of air . Heat is the biggest factor in failure of these units !
Geo
Geo
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content