How to install 1979 AT shifter indicator plate needle
Forum: C3 Electrical, Body and Interior
I was replacing a defective power window switch. I had to loosen the console to get at the switch. On doing so, I apparently broke off the AT shifter needle. I can’t figure out how to put in the replacement.
Sign In to Like this post
Moderator
Can you post a pic of the shifter and replacement needle?
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Sign In to Like this post
Just got your reply, thank you. I’ll send the pictures after church tomorrow. I hope you can help me out. Thanks again, Phil
Sign In to Like this post
Sign In to Like this post
Sign In to Like this post
Moderator
If memory serves, you should be able to replace the indicator from the side. Just remove the side panel/skirt. There is a metal bracket with a pin on it that the slot on the needle fits into. Remove the bracket(1 bolt?) and slide the old indicator off, and the new one on, then replace the bracket. Make sure to get the pin on the bracket aligned with the slot on the indicator.
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Sign In to Like this post
Did you get my pictures? Took me a couple tries to get them uploaded.
Sign In to Like this post
Thank, I’ll give it a shot
Sign In to Like this post
Which side are you coming in from? The picture shows from the driver side.
Sign In to Like this post
Moderator
Yes...driver side. btw, the diagram I posted is for '77-'81 shifters.
|UPDATED|8/16/2021 6:10:34 PM (AZT)|/UPDATED|
Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Sign In to Like this post