Sponsored Content
C
After some months of storage, my hood latch on my 1975 Conv did not release the hood. I am lost as how to start to open the hood. Before driving it any distance, I would like to check the oil and tranny fluid. ANYONE, PLEASE HELP ME! WHAT METHOD SHOULD I USE TO OPEN THE HOOD? 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
r
Former Member
Send PMBladenboro, NC - USA
Joined: 1/22/2006
Posts: 1058
Vette(s): 1972 conv., sunfire yellow, blk interior, blk vinyl and convertible top. Off frame restoration with American Speed 383 stroker engine producing 500hp plus a 200hp NOS system. MSD ignition. Hooker super competition headers with chambered exhaust.
Here's an old thread that might help. Good Luck!!
http://www.VetteRegistry.net/forum/forum_posts.asp?TID=67343&KW=hood+release
http://www.VetteRegistry.net/forum/forum_posts.asp?TID=67343&KW=hood+release
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
r
Former Member
Send PMBladenboro, NC - USA
Joined: 1/22/2006
Posts: 1058
Vette(s): 1972 conv., sunfire yellow, blk interior, blk vinyl and convertible top. Off frame restoration with American Speed 383 stroker engine producing 500hp plus a 200hp NOS system. MSD ignition. Hooker super competition headers with chambered exhaust.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Moses Lake, WA - USA
Joined: 4/16/2005
Posts: 2134
Vette(s): 1976 L48 4-spd, Mahogany Metalic exterior, Buckskin interior 350ci/350hp, 3rd owner, fiberglass spring, 255/50-16's Torq-Thrust II
Is the cable broken? If so here is how I opened mine. Had to do it a couple of times so I have 2 methods. There is a hole through the firewall but it could have a plastic plug in it. If so pop it out. The hole is located on the left side above the brake master cylinder in the wiper well. Feel around, you will find it. Take a screw driver or stiff rod an slide it through the hole. You will need to move it around until you contact a tab that is on the latch lever. Then push and it will release the latch. It will take awhile and may be a bit frustrating to find the right spot.
The second method I used was to remove the triangular cover on the bottom of the fender that fills the opening between the frame, fender and wheel wheel. Reach your hand up through the opening an feel around above the brake master cylinder. You will feel a little tab hanging down from the hood. Push the tab towards the front of the vette.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content