Has anybody ever replaced one of these? I have the part but dont see any simple way of doing this. Do you have to pull the dash out or is there an easier way?
If I have to pull the dash does anybody have any suggestions or tips for doing it with a minimum of grief?
Herb H
Sign In to Like this post
I hope you can make like a contortionist. 
Wiggle the duct tube off, then use a small mirror and a light and get a good look at where the 2 phillips head screws are on each side of the vent outlet. With a lot of patients and an uncomfortable position under the dash, remove the 2 screws and the vent outlet will come out. Upon reassembly put a little "dumdum" or sticky stuff on the end of the screwdriver to hold the screw on to get it started. I just did this on my '81 not to long ago.
Good luck!
Sarge
GEN III 5.7L "LS6" Engine swap
TKO500 5 spd.
Borgeson Steering Box
Born 8/1981
Sequence #3975
Click here to see more pics of my Vette on CarDomain.
Lifetime Member #26
Sign In to Like this post
Sarge -
I made like a contortionist and am still sore
. Solved the problem though - at least almost. I got one of the two bolts holding the duct vent to the dash - the other one was hopeless. I have a much younger and more flexible buddy and I am going to draft him for the chore.
Anyway - thanks for the tip 
. It will be fixed soon.
Herb H
Sign In to Like this post