Headlights Flash or Flicker On and Off
Forum: C3 Electrical, Body and Interior
5 Messages
Page 1 of 1
Sponsored Content
I don't often drive my car at night, but the other day when I put on my high beams they would go out and then come back on. If I put on the low beams the lights would flicker. I replaced the headlight switch a few months ago as I couldn't pull the knob easily. I checked the wiring and ground and they seem okay. The lights don't look like they are higher wattage. Ant ideas where I could look? Thank you.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
c
Former Member
Send PMPhoenix, AZ - USA
Joined: 6/12/2011
Posts: 139
Vette(s): 1982 corvette crossfire production numer C5101985. Color is silver and claret. All original numbers match. slight mods to crossfire for better efficiancy and power balanced and added fuel pressure assembly between throttle bodies,
did they flicker before you changed the headlight switch?
|UPDATED|8/8/2013 8:19:03 PM (AZT)|/UPDATED|
did you check the ground at your dimmer switch?
I had an old chevy pick up that did the same thing, I am trying to remember what i did to correct the issue, I believe the pigtails for the lights were corroded and I replaced the wiring and connector to the lights.
|UPDATED|8/8/2013 8:19:03 PM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22715
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
Same question for me...were they doing that BEFORE you changed the headlight switch? If they were, then I would be looking at the dimmer switch itself....it's down on the floor, where it can get a LOT of nasty stuff in it, including water. 
If they were NOT doing this before, then I would think the problem is the "new" headlight switch. There have been many posts about new switches not working properly right out of the box.
If they were NOT doing this before, then I would think the problem is the "new" headlight switch. There have been many posts about new switches not working properly right out of the box.
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Free Member
Send PMOak Creek, WI - USA
Joined: 5/21/2008
Posts: 2041
Vette(s): 1981 Great White Shark. Red Interior, 350/190 hp. PS, PB (SS), A/C CC, T-Tops. Served three years in Active Duty Army, then Retired Air Force after 34 years! Badger State Vettes Car Club. 175,000 Original miles!! Now own a 1998 C-5!
miccar said: I don't often drive my car at night, but the other day when I put on my high beams they would go out and then come back on. If I put on the low beams the lights would flicker. I replaced the headlight switch a few months ago as I couldn't pull the knob easily. I checked the wiring and ground and they seem okay. The lights don't look like they are higher wattage. Ant ideas where I could look? Thank you.
Look at the connections at the headlights!! Clean them good with a wire brush or sandpaper. My headlights did that but as soon as I cleaned the electrical connections the problem was solved!!
Dan da Man
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
The lights weren't flickering before I changed the switch. It was just difficult to pull and push the knob, but I never drove the car much at night so maybe the problem existed before and I didn't know about it.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content