Sponsored Content
The pin and spring on my 75 that holds the gas pedal on keep coming lose and falls out. I have both the pin and spring,am I missing a part that holds this assembly in?
Rick
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Free Member
Send PMOak Creek, WI - USA
Joined: 5/21/2008
Posts: 2041
Vette(s): 1981 Great White Shark. Red Interior, 350/190 hp. PS, PB (SS), A/C CC, T-Tops. Served three years in Active Duty Army, then Retired Air Force after 34 years! Badger State Vettes Car Club. 175,000 Original miles!! Now own a 1998 C-5!
Yup, There is a little washer thingy that goes on the end of the shaft to hold it in place!!
Dan
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
On mine its just the spring and the pin. Its suppose to be a tight fit, but when the plastic pedal hole gets worn out the pin falls out. I know its a PITA
to get it back together. "T"
to get it back together. "T"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I looked in the AIM manual ,but I couldn't find a picture to see if they used the clip on 75's.Dose anyone know when they started using them.
Rick
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content