Sponsored Content
d
Some of the ratio's for paints get a little odd. Basically. it's paint, reducer, activator. I'm not sure what the 4th component would be if it's not the flex.
Most counter people know their products inside out, some do not. What brand of urethane are you using? I'll get you the product # for the flex. You don't need much,, maybe an ounce to a gun cup.
Once again, I agree with Ken, the HVLP is the way to go.
The gravity fed is my favorite type.
Don't forget, respirator and exhaust fan!
Most counter people know their products inside out, some do not. What brand of urethane are you using? I'll get you the product # for the flex. You don't need much,, maybe an ounce to a gun cup.
Once again, I agree with Ken, the HVLP is the way to go.
The gravity fed is my favorite type.
Don't forget, respirator and exhaust fan!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Send PMHot Springs, AR - USA
Joined: 4/24/2004
Posts: 3236
Vette(s): 69 Conv #'s match 427, TKO-600/.64, 3.36HD-Posi, HT, T/T, PS, PB, PW, SP, Leather, Comp XE264HR & Roller Rockers & Lifters, Air-Gap RPM intake, Holley St Av 770 VS, MSD 6AL+Dist+Blaster SS, K&N, Jet-Hot Hooker Side-Pipes, Steeroids, Al Rad, Spal Fans
I have an HVLP but it is bottom fed.. not gravity..
the fan and respirator are a must..
i havent gotten to the point of painting yet..
waiting for the eastwood to show up..
it mixes 80/20 with laquer thinner to spray..
|UPDATED|12/7/2004 9:20:34 PM (AZT)|/UPDATED|
the fan and respirator are a must..
i havent gotten to the point of painting yet..
waiting for the eastwood to show up..
it mixes 80/20 with laquer thinner to spray..
|UPDATED|12/7/2004 9:20:34 PM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content